Supported hardware The hpsa driver supports the following Smart Array boards:Ĭonfiguration details To configure HP Smart Array controllers, use the HP Array Configuration Utility (either hpacuxe(8) or hpacucli(8)) or the Offline ROM-basedĬonfiguration Utility (ORCA) run from the Smart Array's option ROM at boot time.ĭevice nodes Logical drives are accessed via the SCSI disk driver ( sd(4)), tape drives via the SCSI tape driver ( st(4)), and the RAID controller via the These older boards have not been tested and are not supported with hpsa, and cciss(4) should still be used for these. Predates the RAID controller, though it may also be used to enable hpsa to drive older controllers that would normally be handled by the cciss(4)ĭriver. Typically this is used to allow installation of operating systems from media that This allows newer hardware to work with older drivers. Options hpsa_allow_any=1: This option allows the driver to attempt to operate on any HP Smart Array hardware RAID controller, even if it is not explicitly Hpsa is a SCSI driver for HP Smart Array RAID controllers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |